网站公告

当前位置:首页-网站公告

仿古金属单体瓦安装过程的细部介绍

来源:http://www.luchuangjiancai.com/ 时间:2021-08-12 浏览量:

金属瓦瓦屋脊龙骨的排布在金属瓦的安装过程中至关重要,决定着面瓦的安装是否完成尺寸是否合适瓦表面是否安装整洁,屋脊龙骨首先根据屋脊高度适配龙骨具体尺寸,屋脊龙骨与屋面龙骨之间进行焊接,以保证整体强度,焊接部位要做防锈处理来确保安装完成后时间问题造成的锈蚀断裂。

The arrangement of metal tile ridge keel is very important in the installation process of metal tile, which determines whether the installation of face tile is completed, whether the size is appropriate, and whether the tile surface is installed neatly. Firstly, the ridge keel adapts the specific size of keel according to the ridge height, and the ridge keel and roof keel are welded to ensure the overall strength, The welding parts shall be treated with rust prevention to ensure the corrosion and fracture caused by the time problem after installation.

龙骨在安装中横龙骨的位置应从下往上排布,靠近屋脊处15CM要放置一根龙骨。横龙骨在焊接前需进行调平处理,然后进行焊接。屋脊筒瓦的侧面板底部安装时要预留2CM的距离,以便侧面底板与屋面筒瓦之间安装正勾当,正勾当的上沿小尺寸为2公分。
During the installation of keel, the position of horizontal keel shall be arranged from bottom to top, and a keel shall be placed 15cm near the ridge. The horizontal keel shall be leveled before welding, and then welded. When installing the bottom of the side panel of the ridge tube tile, a distance of 2cm shall be reserved to install the positive activity between the side bottom plate and the roof tube tile. The small size of the upper edge of the positive activity is 2cm.
正勾当、侧板与屋脊龙骨使用@5*20的铆钉进行铆接。安装屋脊时因斜勾当的尺寸是非标准尺寸需现场进场测量进场现场裁剪制作,所以在场内生产的尺寸都会偏大,使用时需进行现场制作,实际使用出厂使用面积会大于实际使用面积,在结算面积时要按一定比例进行增加使用面积。
Use @ 5 * 20 rivets to rivet the front activities, side plates and roof keel. When installing the ridge, because the size of the inclined activity is non-standard, it needs to be measured on site, cut and made on site, so the size produced on site will be too large, and it needs to be made on site when in use. The actually used ex factory use area will be greater than the actual use area, and the use area shall be increased according to a certain proportion when settling the area.